Honeywell Photoelectric Smoke/Heat Detector with Built-in Wireless Transmitter

Honeywell Photoelectric Smoke/Heat Detector with Built-in Wireless TransmitterHoneywells 5808W3 is a 3V lithium powered, photoelectronic smoke/heat detector with a built-in wireless transmitter. It is intended for use with any 5800 Series Wireless Receiver/Transceiver for residential installations (for commercial installations, the 5881ENHC or the 5883H receiver is required).The transmitter can send alarm, tamper, maintenance (when control panels are equipped to process maintenance signals), and battery condition messages to the systems receiver. Smoothing algorithms minimize nuisance alarms by smoothing out short term spikes from dust and smoke virtually eliminating nuisance alarms.Since there are no holes to drill or wires to run, you can preserve the beauty of the building while protecting it. The 5808W3 is an ideal smoke detector for those difficult to wire locations, applications where room aesthetics are critical, or where hazardous materials exist.All models also feature a restorable, built-in, fixed temperature (135F) thermal detector that is also capable of sensing a pre-freeze condition if the temperature is below 41F.Features:Improved Robust RF Field StrengthThe distance between the detector and receiver has been significantly increased without the need for a repeaterSmoothing AlgorithmsMathematical calculations in the detectors software that minimize nuisance alarms by smoothing out short term spikes from dust and smokeSmart CheckA signal is sent to the control panel when the detector requires cleaning. This allows a regular, non-emergency service call to clean the detector before it goes into alarm.Drift CompensationVirtually eliminates nuisance alarms from long-term dust build-up by automatically adjusting the detectors sensitivityRemovable Detector Cover and Chamber TopThe technician is able to quickly and easily clean the detector chamber without disassembling the detector headApproved UL Listings for Residential and Commercial ApplicationsBoth residential and commercial installation requirements are metAdditional LED Status IndicatorsIdentifying between alarm or trouble conditions is a snap with green and red LED status indicators. A green LED denotes a normal condition while the red LED indicates abnormal conditions.Easy-to-install Mounting BaseThe sturdy mounting base allows the detector to be more easily installed on uneven surfaces (i.e. stucco). The mounting base has larger mounting ports, which accommodate drywall anchors for easy surface mounting.ADDITIONAL FEATURES:Utilizes one long-life 3V lithium batteryMicrocontroller runs on a 4.0 MHz clockHorn operates at 3.3 KHz with sound pressure level of 85 dBA at 10 feetBuilt-in wireless transmitter, temporal code 3 sounderMaintenance signal fully complies with the sensitivity test requirement specified in NFPA 72, 7-2.2 and is approved by UL